Crestron D3 PRO Reference Manual page 23

™
Crestron D3 Pro
Reference Guide – DOC. 5998a
To combine text areas
1. Verify that Show Text Area Outlines is enabled on the right-click submenu.
2. Click each text area while pressing the Ctrl key. (You can only group two
text areas at a time.)
3. Right-click and choose Combine Text Areas from the submenu.
4. If you have two long text areas in one row, you can repeat steps 2 and 3 to
create one text area that stretches across the entire row.
5. To revert to the smaller text area setting, select the long text area, right-click
and choose Uncombine Text Areas from the submenu.
Entering Text and Lines - When you enter text in an engravable area, you can also
draw lines around the text and button(s). In this way you can separate buttons from
one another, or you can create a border around related buttons.
To enter text
1. Double-click the engravable text area.
2. Go to Field One and select a font from the Font list.
As shown in the diagram on page 18, you can choose from two fonts: Arial,
for readable text; and Crestron Transport Outline, which consists of
symbols that represent standard device functions such as Fast Forward,
Rewind, Volume Up and Volume Down. Each symbol corresponds to a letter
of the alphabet from A to P, not case sensitive.
After selecting the font, enter the desired text in the Field One text box.
If you enter text only in the Field One text box, you can align the text
horizontally and vertically by selecting from the Align Text lists.
3. You can click the Field Two check box to enter a second line of text. Here
you can choose a font just as described above.
4. You have the further option to place Field One on top of Field Two (click
Two Horizontal Fields), or to place the two fields next to each other (click
One Horizontal Field). Choose the latter if you want to use two different
fonts within the same line.
If you have text in Field One and Field Two, you can only align the text
horizontally, not vertically.
To draw lines around a text area
1. After you enter the desired text and align it within the text area, select the
check boxes that appear around the drawing of the text area and button.
For example, if you want to draw a vertical line on the left side of the text
area/button(s), click the check box on the left side. To draw a border around
the entire area, click all four check boxes.
Software
Crestron D3 Pro™• 19