Crestron D3 PRO Reference Manual page 24

Software
20 • Crestron D3 Pro™
2. Click OK to save your settings. D3 Pro will verify that the text you entered
will fit within the margins of the engravable area. If the text does not fit, an
error message will be generated.
3. You can right-click and select Show Lines on the submenu to display any
lines you have drawn. (You can hide the dotted lines that show engravable
areas by toggling Show Text Area Outlines on the right-click submenu.)
Replacing center buttons with text and lines - This feature allows you replace
center buttons with horizontal text and lines, in the manner shown below:
To replace center buttons with text and lines
1. Use the methods described earlier to hide two center buttons. Two text areas
will replace the buttons.
2. Combine the two text areas you just created into one text area.
3. Double-click the new text area and enter the desired text.
4. Select the Text Area check box to add a horizontal line on either side of the
text.
Crestron D3 Pro
Reference Guide – DOC. 5998a
™