Industry Compliance; Important Notes - Crestron CLW-DIM1RF Manual

Physical view of CLW-DIM4RF/-DIMS4RF
(clockwise from top; Top, Side, and Front)
1.75 in
(4.45 cm)
2.38 in
(6.03 cm)
3.81 in
(9.68 cm)
3.28 in
(8.32 cm)
RUN SET OFF
Physical view of CLW-SLVD1RF (clockwise from top; Top,
Side, and Front)
1.75 in
(4.45 cm)
3.81 in
(9.68 cm)
3.28 in
(8.32 cm)
(10.48 cm)
These devices mount in a standard wallbox and are
covered using a decorative faceplate (not included).

Industry Compliance

This product is Listed to applicable UL Standards and
requirements by Underwriters Laboratories Inc.
Installation Guide – DOC. 6292A
1.88 in
(4.77 cm)
2.70 in
4.13 in
(6.86 cm)
(10.48 cm)
1.50 in
(3.81 cm)
1.88 in
(4.77 cm)
2.70 in
4.13 in
(6.86 cm)
1.50 in
(3.81 cm)
E239011
infiNET™ Wall Box Dimmer: CLW-DIM1/4RF, DIMS1/4RF, & SLVD1RF • 3
infiNET™ DIMMERS
FCC ID: EROCWD1011
Compliance Statement (Part 15.19 )
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received,
including interference that may cause undesired
operation.
Warning (Part 15.21)
Changes or modifications not expressly approved by the
party responsible for compliance could void the user's
authority to operate the equipment.
RF Exposure (OET Bulletin 65)
To comply with FCC's RF exposure limits for general
population / uncontrolled exposure, this transmitter must
be installed to provide a separation distance of at least
20 cm from all persons and must not be co-located or
operating in conjunction with any other antenna or
transmitter.
Industry Canada Statement
The term "IC" before the certification/registration number
only signifies that the Industry Canada technical
specifications were met.
IC: 5683A-CWD1011

Important Notes

Read before installation.
•
Codes: Install in accordance with all local and
national electrical codes.
• CAUTION
: TO REDUCE THE RISK OF
OVERHEATING AND POSSIBLE DAMAGE
TO OTHER EQUIPMENT, DO NOT INSTALL
TO CONTROL A RECEPTACLE OR A
MOTOR OPERATED APPLIANCE (i.e. BATH
FAN).
•
Wiring: Use copper wire only. For supply
connections, use wires rated for at least 75°C.
•
Lamp Type: The -DIM1RF, -DIM4RF,
-DIMS1RF, -DIMS4RF, and -SLVD1RF are
designed for use with permanently installed
incandescent, magnetic low voltage, or tungsten-
halogen only.
•
Temperature: The -DIM1RF, -DIM4RF,
-DIMS1RF, -DIMS4RF, and -SLVD1RF are
designed for use where temperatures are between
32° to 104°F (0° to 40°C).