Table of Contents
Advertisement
VIP X16 XF E
The encoder offers the serial interface via the terminal block.
The range of controllable equipment is expanding constantly. The manufacturers of the
relevant equipment provide specific information on installation and control. Please take note
of the appropriate documentation when installing and operating the unit to be controlled. The
documentation contains important safety instructions and information about permitted uses.
CAUTION!
Please observe the labeling on the unit.
1.
2.
Further topics:
–
5.6
Power on/power off
The VIP X16 XF E is delivered together with two power cords, one for EU, one for US mains
socket-outlets.
CAUTION!
Use only the suitable power cord. Where necessary, use suitable facilities to ensure that the
power supply is free of interference such as voltage surges, spikes or brownouts. Connect the
unit to an earthed mains socket-outlet.
Do not connect the unit to the power supply until all other connections have been made.
1.
2.
Provided the network connection has been correctly made, the LINK LED also lights up. The
flashing LED ACTIVITY signals traffic on the network.
Bosch Sicherheitssysteme GmbH
If you require a serial connection to the VIP X16 XF E encoder, connect the relevant
cables to the terminal block and check that the connections are secure.
Connect the terminal block to the socket on the unit observing the labeling.
Section 7.7 Terminal block, page 24
Select the suitable power cord and connect it to the unit.
Plug the power cord into the mains. The unit is ready for use as soon as the CONNECT
LED lights up.
Installation Manual
Connection | en
19
F.01U.281.864 | V2 | 2012.12
Advertisement
Table of Contents
