Supermicro SuperServer 5019A-FN5T User Manual page 52

SuperServer 5019A-FN5T User's Manual
10Gb LAN Enable/Disable
Use jumper JPTG1 to enable or disable 10G LAN2/3/4/5. Refer to the table below for jumper
settings.
SMBus to PCI Slots
Jumpers JI C1 and JI
2
PCIe slots. Both jumpers must be set to the same setting (JI
controls the data). The default setting is Disabled.
BIOS Recovery
Close pins 2-3 of jumper JBR1 for BIOS recovery. The default setting is on pins 1 and 2 for
normal operation. Refer to the table below for jumper settings. The default setting is Normal.
PCIe Slot Selection
Use jumper JSEL1 to select between PCIe x8 slot 6 or slot 7. Only one PCIe slot can be
used at a time.
10Gb LAN Enable/Disable
Jumper Settings
Jumper Setting Definition
Pins 1-2 Enabled (Default)
Pins 2-3 Disabled
C2 allow you to connect the System Management Bus (I
2
SMBus to PCI Slots
Jumper Settings
JI C1 Setting JI C2 Setting
2 2
JI C1: Pins 1-2 JI C2: Pins 1-2
2 2
JI C1: Pins 2-3 JI C2: Pins 2-3
2 2
BIOS Recovery
Jumper Settings
Jumper Setting Definition
Pins 1-2 Normal
Pins 2-3 BIOS Recovery
PCIe Slot Selection
Jumper Settings
Jumper Setting Definition
Pins 1-2 Slot 7 (Default)
Pins 2-3 Slot 6
52
C1 controls the clock and JI
2
Definition
Enabled (Default)
Disabled
C) to the
2
C2
2