Ethernet Leds - Sierra Wireless AirLink LX40 Hardware User's Manual

AirLink LX40 Series Hardware User Guide
Table 2-9: LED Behavior
LED Color / Pattern
Note: The quality of the signal strength is measured using the appropriate parameters for the radio technology in use.
Network Solid Green
Solid Amber
Flashing Green
Flashing Green
(3 sec. on/1 sec. off)
Flashing Red
Flashing Amber
Flashing Red / Amber
ALL Green LED chase
Amber LED chase
Solid Amber
Red LED chase
a. May result from ALMS not reporting the R2C eSIM activation state (the LX40, the eSIM, and ALMS have not synchronized
after device registration or a device reset), or status reports from ALMS have been disabled. Network or server issues may
also result in an unknown activation state.

Ethernet LEDs

The connector has two LEDs that indicate speed and activity. When looking into the
connector:
•
•
Rev. 2 January 2021
Connected to an LTE network (using SIM card or R2C eSIM)
Connected to a 3G or 2G network
Connecting to the network
WAN over Wi-Fi (LX40 is in Wi-Fi client mode)
No network available, R2C eSIM not activated
R2C eSIM activation state unknown
Network Operator Switching is enabled, but the router is unable to locate the
required firmware. For more information, refer to the ALEOS Software
Configuration User Guide (Admin chapter).
Radio module reconfiguration/firmware update or Network Operator
Switching is in progress
ALEOS software update is in progress
ALEOS software update complete
Recovery mode
Activity—The right LED indicates the link status:
· Solid—Link
· Blinking Amber—Activity
· Off—No link
Connection Speed—The left LED indicates the Ethernet connection speed:
· Solid Green—1000 Mbps (Gigabit)
· Off—10/100 Mbps
Description
a
32 41112510