Reboot The Lx40; Reset The Lx40 To Factory Default Settings - Sierra Wireless AirLink LX40 Hardware User's Manual

AirLink LX40 Series Hardware User Guide
•
•
•
•
•
•
To get started, either call your AirLink reseller or visit:
www.sierrawireless.com/ALMS
Configuring with AMM
AirLink Mobility Manager (AMM) is a Network Management solution that enables simplified
management, control and monitoring of connected AirLink routers. AMM is a licensed,
unified software platform deployed in the enterprise data center. It enables:
•
•
•
If you require a network management solution deployed in your data center, contact your
Sierra Wireless sales representative for a demonstration of the AMM capabilities.
Configuring with AT Commands
For a complete list of AT commands, refer to the ALEOS Software Configuration User
Guide.

Reboot the LX40

To reboot the LX40, either:
•
•

Reset the LX40 to Factory Default Settings

To reset the router to the factory default settings:
•
Rev. 2 January 2021
Continuous status monitoring of important health data such as signal strength
Location monitoring, including world map views
Complete ALEOS reporting and configuration, including historical views of ALEOS
information
Configure individual routers or use templates to perform batch configurations of your
AirLink routers
Single-click over-the-air firmware updates to all your routers
Compatible with all carriers or mobile network operators
Mobile network and asset management
Over-the-air registration, configuration and software updates
Consolidated network view of an entire fleet, in-field applications and mobile assets,
using a virtual dashboard to monitor, report, manage, and troubleshoot all mobile
resources as required.
On the router, use a tool such as a paper clip or small screwdriver to press the Reset
button for less than 5 seconds. (Release the button when the Power LED flashes
green.) The reset button is recessed approximately 5 mm (1/4 inch), which prevents
casual use of a pen for resetting the router. The Reset button is small, so ensure that
the tool fully contacts the button.
In ACEmanager, click the Reboot button on the toolbar.
In ACEmanager, go to Admin > Advanced and click the Reset to Factory Default
button.
34 41112510