Sierra Wireless LX40 Connecting Manual

C C o o n n n n e e c c t t i i n n g g a a S S i i e e r r r r a a W W i i r r e e l l e e s s s s L L X X 4 4 0 0 L L T T E E R R o o u u t t e e r r t t o o a a n n E E a a t t o o n n N N e e t t w w o o r r k k C C a a r r d d
I I n n t t r r o o d d u u c c t t i i o o n n
This document provides instructions for connecting a Sierra Wireless LX40 LTE Router to one of the following
Eaton connectivity cards:
• Industrial Gateway Card (INDGW-M2)
• Gigabit Industrial Gateway X2 Card (INDGW-X2)
• Gigabit Network (Network-M2)
P P r r e e r r e e q q u u i i s s i i t t e e s s
• Eaton UPS with a INDGW-M2, INDGW-X2, or Network-M2 card loaded with the latest firmware
• Environmental Monitoring Probe Gen 2
• PredictPulse LTE Modem Kit, part number P-154000455
• USB-to-USB (MicroUSB B)
• CAT5 ethernet cable
• Download the latest card firmware and RNDIS driver from the Eaton product site:
–
–
Go to the Resources page and scroll down to the Software, firmware, and applications section. Click
the links to download the firmware and RNDIS driver files.
I I N N D D G G W W - - M M 2 2 o o r r I I N N D D G G W W - - X X 2 2 C C a a r r d d I I n n s s t t a a l l l l a a t t i i o o n n
The hot-swappable INDGW-M2 and INDGW-X2 cards (see
turning off the UPS or disconnecting the load. To install the card:
1. Ensure that the UPS has logic power.
2. Remove the two screws securing the Minislot or X-slot cover and remove the cover from the UPS. Retain
the screws.
3. Remove the INDGW-M2 or INDGW-X2 card from its shipping package.
4. Slide the card into the open slot. Secure with the screws removed in
5. Wait for the Warning LED (see
operational. The ON LED also flashes green when the card is ready.
NOTE The Network-M2 has now reached end-of-life (EOL) status.
NOTE The router contained in the PredictPulse LTE Modem Kit must be powered by a 120V
electrical outlet powered by the UPS. This ensures that the router is protected during a
power outage. If no UPS-protected outlet is available, a Universal Accessory Power
(UAP) kit is required. The UAP must be installed by an Eaton technician. Contact your
Eaton service representative for a quote.
For the INDGW-M2 card, go to
https://www.eaton.com/us/en-us/catalog/backup-power-ups-surge-it-power-distribution/eaton-
industrial-gateway-card.resources.html
For the INDGW-X2 card, go to
https://www.eaton.com/us/en-us/catalog/backup-power-ups-surge-it-power-distribution/eaton-gigabit-
industrial-gateway-card.html.
Connecting a Sierra Wireless LX40 Router to an Eaton Network Card
Figure 1
Figure 1 or Figure 2) to flash only green to indicate that the card is
and Figure 2) can be installed without
Step 2.
P-164001160—Rev 01 1