Din Rail Mount - Sierra Wireless AirLink LX40 Hardware User's Manual

DIN Rail Mount

You can mount the LX40 on a DIN rail in a vertical orientation, with the antenna
connectors pointing up or down.
Note: The DIN rail mounting clip should only be used on a horizontally-mounted DIN rail.
Ensure spring clip
is at the bottom
Figure 2-6: Attaching the DIN Rail Mounting Clip
To attach the LX40 to a horizontally mounted DIN rail:
Note: Before installing the LX40 in its final location, you may want to install the SIM card (see
page
connectivity (see
proceed with the procedure below.
1. Secure the LX40 in the mounting bracket, as described on
2. Use the screws provided to attach the DIN clip to the bracket. Attach the clip in the
3. Attach the DIN rail clip to a horizontal DIN rail, with the spring clip at the bottom.
Rev. 2 January 2021
13), attach antennas (see
page 30). After a successful test, you can remove cables and antennas and
direction to achieve the desired position for the LX40. In the final orientation, the
spring clip should be at the bottom. Torque the screws to a maximum of 1.1 N-m (10
in-lb.).
To mount the LX40 with antenna
connectors pointing down, rotate the
DIN clip 180 degrees before attaching.
page 18), power up the device (see
17
Installation and Startup
page 19) and test the network
page 15.
41112510