Figure 2-3: Ground connector
Flat Mount
To mount the LX40 permanently to any surface or if you are mounting the LX40 on a DIN
rail, order an LX40 mounting bracket kit (P/N 6001221) from Sierra Wireless. The kit
contains:
•
•
•
To mount the LX40 on a flat surface:
1. Attach the bracket to the mounting surface, using the attachment points shown in
2. Snap the LX40 onto the bracket (see
Rev. 2 January 2021
Grounding point
Mounting bracket
DIN rail clip (35 mm EN 50022) (see
Screws for attaching the DIN rail clip to the mounting bracket
Figure
2-4.
Figure 2-4: Mounting Bracket, showing attachment points
a. Angle the LX40 with the antenna connectors downwards, and fit the bracket
clasps against the indentations on the end of the LX40. The raised edge of the
bracket should match the rounded corner of the LX40.
b. Bring the other end of the LX40 down onto the bracket and snap it into place. The
bracket clasps should fit into the indentations on the end of the LX40.
DIN Rail Mount
Holes are Ø 4.3 mm (M4 compatible;
use hardware appropriate for your
mounting surface)
Figure 2-5
on page 16).
15
Installation and Startup
on page 17)
41112510