GE Multilin EPM 2000 Series Instruction Manual page 24

First, you must enter the Main Menu and reach "SET" using the previous Table. This example
illustrates changing System Mode (SYS) from "Star" to "Delta".
Action
Press to enter SET
Press to edit
We have now reached SYS (top
row) for editing.
Press to view Value.
Press to edit SYS value.
The value blinks.
Press to change to Delta 2E.
Press to accept the value.
We're done. Press to head
back.
Press again.
Press to accept "y" (yes, save) "PASS"
GE Multilin
Table 2-4: Editing the Setup Values
Display
"Set" You're in the Main Menu.
SYS Wiring System.
V.PRI Voltage primary.
V.SEC Voltage secondary.
"StAR" Wiring System = Star 3E
415.0 Voltage primary = 415v.
415.0 Voltage secondary = 415v.
"StAR" Wiring System = Star 3E
415.0 Voltage primary = 415v.
415.0 Voltage secondary = 415v.
" Star " Blinks. Only Top Row is edited
415.0 Ignore
415.0 Ignore
" Delta " Blinks. Note: To discard the change:
415.0
•
Press
415.0
•
Restores the previous value.
"Delta" Steady. SYS is now set to Delta.
415.0 Press
415.0 other values.
" SYS "
Blinks
"Save" NOTE: To discard present changes, press
" y " show "Save n".
Stores the Setup changes.
"Set" Now, you're back in the Main Menu and can
go to "RUN" and
Sub Meters
Remarks
.
to scroll down, and to change
to "RMS".
to
24