Troubleshooting - Raider Pro RDP-SGC08PRO User Manual

Problem
No coating material is coming out of the
nozzle
The coating material drips from the nozzle The nozzle is loose
Spray too coarse
The spray jet pulses
Run in the coating material
Too much coating material mist
(overspray)
Environmental protection.
In order to protect the environment, the power tool, accessories and packaging must be suitably processed for the reuse of the raw
materials contained therein. Do not dispose of power tools in household waste! According to the EU Directive 2012/19 / EC on end-
of-life electrical and electronic devices and its validation as a national law, power tools that can no longer be used must be separately
collected and subjected to appropriate processing to recover the contents in them valuable secondary raw materials.

Troubleshooting

Cause
The nozzle is blocked
The ascending pipe is blocked
The small hole in the ascending pipe is blocked
Material adjustment knob turned too far to the (-)
The ascending pipe is loose
No pressure is built up in the container
The nozzle is worn
Build up of coating material in the air cap and
nozzle
Coating material has a too high viscosity
Too much material
Material adjustment knob turned too far to (+)
Nozzle dirty
Air filter very dirty
Not enough pressure built up in container
Coating material in container is running out
The small hole in the ascending pipe is blocked
Air filter very dirty
Too much coating material applied
The distance to the object to be sprayed is too
large
Too much coating material applied
Remedy
Clean
Clean
Clean
Turn to the (+)
Tighten pipe
Tighten container
Tighten
Change
Clean
Dilute
Turn material adjustment knob to (-)
Clean
Change
Tighten container
Refill
Clean
Change
Turn the material
adjustment knob to the (-)
Reduce spraying distance
Turn material adjustment
knob to the (-)
21