Raider Pro RDP-SGC08PRO User Manual page 14

14 www.raider.bg
affect its operational. A guard or other part char is damaged could be properly repaired or replaced by an
authorized service center unless otherwise indicated in this instruction manual. Have defective switches
replaced by an authorized service facility. Do not use the tool if the switch does not turn it on and off.
21) Warning.
--The use of any accessory or attachment, other than those recommended, in this instruction manual,
may present a risk of personal injury.
22) Have your tool repaired by a qualified person.
-- This electric tool is in accordance with the relevant safety requirements. Repairs should only be carried
out by qualified persons using original spare parts, otherwise this may result in considerable danger to the
user.
If the supply cord is damaged, it must be replaced by a special cord or assembly available from the
manufacturer or its service agent.
Safety Instructions for Spray Guns
● Do not use the spray guns to spray flammable substances.
● Do not clean guns with flammable solvents, which have a flashpoint under 21°C
● Beware of any hazards presented by the material being sprayed and consult the markings on the
container or the information supplied by the manufacturer of the material to be sprayed, including
requirements for the use of personal protective equipment.
● Do not spray any substances whose hazard potential is not known.
● You may only spray coating materials such as paints, varnishes, glazes, etc. with a flashpoint of 21°C
(32°C in UK) and higher without additional warning. (German classification of coating material is hazard
classes A II and A III, see material tin.)
● The device may not be used in workplaces covered by the explosion-protection regulations.
● There must be no sources of ignition such as, for example, open fires, smoke of lit cigarettes, cigars
and tobacco pipes, sparks, glowing wires, hot surfaces, etc. in the vicinity during spraying.
● Before working on the spray gun remove the power plug from the socket.
Recommendation: Wear a breathing mask and safety glasses when spraying.
CAUTION - DANGER OF INJURY!
Never point the spray gun at yourself, at other people or at animals.
●
When working with the tool indoors as well as outdoors ensure that no solvent vapors are sucked in by
the spray gun.
● When working outdoors, be aware of the wind direction. Wind can carry the coating substance across
greater distances - thus causing damage. When working indoors, provide for adequate ventilation.
● Do not let children handle the device.
● Never open the device yourself in order to carry out repairs in the electrical system!
● Do not lay the spray gun.
Residual risks
Even when the power tool is used as prescribed it is not possible to eliminate all residual risk factors. The
following hazards may arise in connection with the power tool's construction and design:
1. Damage to lungs if an effective dust mask is not worn.
2. Damage to hearing if effective hearing protection is not worn.
3. Damages to health resulting from vibration emission if the power tool is being used over longer period of
time or not adequately managed and properly maintained.
WARNING! This power tool produces an electromagnetic field during operation. This field may under
some circumstances interfere with active or passive medical implants. To reduce the risk of serious or fatal
injury, we recommend persons with medical implants to consult their physician and the medical implant
manufacturer before operating this machine.