Maintenance And Care - Q'STRAINT INQLINE SECUREMENT Use And Care Manual

• Do NOT wet the Retractors.
• Do NOT wet the Thumb Controller or Wall Control Panel.
• Inspect all cables, make sure they are connected and covered.
• Inspect for pulled wires.
• Always keep wheelchair tie-downs clean and make sure to slowly return them to stowage when not in use.
• All systems and components should be regularly inspected, cleaned and maintained.
o Clean webbing periodically with mild soap and water. After cleaning, fully extend the webbing (and
position them to prevent water from entering retractors) until completely dry.
o Clean bolt threads and re-apply permanent thread locker if bolts are adjusted.
Make sure to prevent contamination of the webbing by keeping it away from polishes, oils or other chemicals
•
(particularly battery acid).
• Frayed, contaminated or damaged webbing should be replaced.
• Broken and worn components should be replaced.
Replace any systems or components (including floor and wall anchorages) that were used during a vehicle collision.

MAINTENANCE AND CARE

Prevent Exposure to Moisture
24