Raider Pro RDP-ESG11P Original Instruction Manual page 16

16 www.raider.bg
Problem
No coating material is coming
out of the nozzle
The coating material drips from
the nozzle
Spray too coarse
The spray jet pulses
Run in the coating material
Too much coating material mist
(overspray)
Cause
The nozzle is blocked
The ascending pipe is blocked
The small hole in the ascending pipe
is blocked
Material adjustment knob turned too
far to the (-)
The ascending pipe is loose
No pressure is built up in the
container
The nozzle is loose
The nozzle is worn
Build up of coating material in the air
cap and nozzle
Coating material has a too high
viscosity
Too much material
Material adjustment knob turned too
far to (+)
Nozzle dirty
Air filter very dirty
Not enough pressure built up in
container
Coating material in container is
running out
The small hole in the ascending pipe
is blocked
Air filter very dirty
Too much coating material applied
The distance to the object to be
sprayed is too large
Too much coating material applied
Remedy
Clean
Clean
Clean
Turn to the (+)
Tighten pipe
Tighten container
Tighten
Change
Clean
Dilute
Turn material adjustment
knob to (-)
Clean
Change
Tighten container
Refill
Clean
Change
Turn the material
adjustment knob to the (-)
Reduce spraying distance
Turn material adjustment
knob to the (-)