Raider Pro RDP-ESG11P Original Instruction Manual page 12

12 www.raider.bg
Watch what you are doing, Use common sense. Do not operate tool when you are tired.
20) Check damaged parts.
Better further use of the tool, a guard or other part that is damaged should be carefully checked
to determine that it would operate properly and perform its intended function. Check for
alignment of moving parts, free running of moving parts, breakage of parts, mounting and any
other conditions that may affect its operational. A guard or other part char is damaged could
be properly repaired or replaced by an authorized service center unless otherwise indicated in
this instruction manual. Have defective switches replaced by an authorized service facility. Do
not use the tool if the switch does not turn it on and off.
21) Warning.
The use of any accessory or attachment, other than those recommended, in this instruction
manual, may present a risk of personal injury.
22) Have your tool repaired by a qualified person.
This electric tool is in accordance with the relevant safety requirements. Repairs should only
be carried out by qualified persons using original spare parts, otherwise this may result in
considerable danger to the user.
If the supply cord is damaged, it must be replaced by a special cord or assembly available
from the manufacturer or its service agent.
Safety Instructions for Spray Guns
Do not use the spray guns to spray flammable substances.
Do not clean guns with flammable solvents, which have a flashpoint under 21°C
Beware of any hazards presented by the material being sprayed and consult the markings on
the container or the information supplied by the manufacturer of the material to be sprayed,
including requirements for the use of personal protective equipment.
Do not spray any substances whose hazard potential is not known.
You may only spray coating materials such as paints, varnishes, glazes, etc. with a flashpoint
of 21°C (32°C in UK) and higher without additional warning. (German classification of coating
material is hazard classes A II and A III, see material tin.)
The device may not be used in workplaces covered by the explosion-protection regulations.
There must be no sources of ignition such as, for example, open fires, smoke of lit cigarettes,
cigars and tobacco pipes, sparks, glowing wires, hot surfaces, etc. in the vicinity during
spraying.
Before working on the spray gun remove the power plug from the socket.
Recommendation: Wear a breathing mask and safety glasses when spraying.
CAUTION - DANGER OF INJURY!
Never point the spray gun at yourself, at other people or at animals.
When working with the tool indoors as well as outdoors ensure that no solvent vapors are
sucked in by the spray gun.
When working outdoors, be aware of the wind direction. Wind can carry the coating substance
across greater distances - thus causing damage. When working indoors, provide for adequate
ventilation.
Do not let children handle the device.
Never open the device yourself in order to carry out repairs in the electrical system!
Do not lay the spray gun.
Residual risks.
Even when the power tool is used as prescribed it is not possible to eliminate all residual risk
factors. The following hazards may arise in connection with the power tool's construction and
design:
1. Damage to lungs if an effective dust mask is not worn.
2. Damage to hearing if effective hearing protection is not worn.
3. Damages to health resulting from vibration emission if the power tool is being used over
longer period of time or not adequately managed and properly maintained.
WARNING! This power tool produces an electromagnetic field during operation. This field
may under some circumstances interfere with active or passive medical implants. To reduce
the risk of serious or fatal injury, we recommend persons with medical implants to consult
their physician and the medical implant manufacturer before operating this machine.