Table of Contents
Advertisement
4
TROUBLESHOOTING, CARE AND MAINTENANCE
4.1
General Instructions
⚠
WARNING
+
Do not make any improper changes to the equipment.
CAUTION
⚠
+
Damaged or worn components may affect your safety and the life of the equipment.
Therefore, immediately replace damaged or worn components. In such a case, contact the
contract partner. The equipment must not be used until it has been repaired. If necessary,
use only original spare parts.
࣑ ATTENTION
+
In addition to the instructions and recommendations for maintenance and care given here,
additional service and/or repair work may be necessary; this must only be carried out by
authorised service technicians.
4.2
Faults and Fault Diagnosis
The equipment undergoes regular quality controls during production. Nevertheless, faults or
malfunctions may occur. Frequently, individual parts are responsible for these disturbances, an
exchange is usually sufficient. Please refer to the following overview for the most common errors and
how to correct them. If the equipment still does not function properly, contact your contract partner.
Error
Grinding sound
Weight is hanging in
the air
Cable is loose
Squeaking & cracking
noises
Cause
Cables or pulleys do not run
clean or are damaged
Cable has been tensioned
too tightly.
Cable not tensioned
properly
Loose or too tight screw
connection(s)
Solution
Visual inspection of the cable run or
pulley bearing
Re-adjust cable tension
Re-adjust cable tension
Check and/or lubricate screw
connection(s)
25
Advertisement
Table of Contents
