Table of Contents
Advertisement
Step 5:
Assembling the cable - Part 1
1.
Fasten one end of the Cable (20) on the left arm frame (8L) with one screw (52), two washers
(64) and one nut (61).
2.
String the cable (20) through the pulley (32) and fasten it along with the pulley covers (31) onto
the left side of the pulley support (27) with one screw (51), two washers (64) and one nut (61)
(see fig. A-A).
3.
String the cable (20) through the pulley (32) and fasten it along with the pulley covers (31) onto
the pulley support (26) with one screw (50), one washer (64) and one nut (61) (see fig. B-B).
Notice! This pulley will be hanging in the air and will be connected to the pulley system in Part
3 of assembling the cable.
NOTICE
L
The pulley is hanging freely in the air at this point. This pulley is mounted to another pulley in
step 7.
4.
String the cable in the reverse order as described in steps 1 and 2 in order to fasten the cable (20)
onto the right side of the multi-gym.
A-A
B-B
17
Advertisement
Table of Contents
