User Information; Important Notes; Safety Instructions; Electromagnetic Compatibility (Emc) - Bosch EPS 807 Original Instructions Manual

en 28 | EPS 807 / 815 | User information
2.

User information

2.1

Important notes

Important information on copyright, liability and warran-
ty provisions, as well as on equipment users and com-
pany obligations, can be found in the separate manual
"Important notes on and safety instructions for Bosch
DIESEL TEST EQUIPMENT". These instructions must be
carefully studied prior to start-up, connection and opera-
tion of the EPS 807 / 815 and must always be heeded.
2.2

Safety instructions

All the pertinent safety instructions can be found in
the separate manual "Important notes on and safety in-
structions for Bosch DIESEL TEST EQUIPMENT". These
instructions must be carefully studied prior to start-up,
connection and operation of the EPS 807 / 815 and must
always be heeded.
2.�

Electromagnetic compatibility (EMC)

The EPS 807 / 815 satisfies the requirements of the
EMC directive 2004/108/EG.
i
The EPS 807 / 815 is a class/category C2 product as
defined by EN 61 800. The EPS 807 / 815 may cause
high-frequency household interference (radio inter-
ference) so that interference suppression may be
necessary. In such cases the user may be required to
take the appropriate action.
|
1 689 979 672 2012-06-26
EPS 807 / 815 and must and must
3.

Product description

�.1

Application

This operating manual describes the injection pump
test bench EPS 807/815.
The EPS 807 / 815 is used in conjunction with the quantity
measurement system MGT 812/824 or KMA 802/822 to
check and set in-line and distributor injection pumps for
diesel engines in workshops.
i
The measurement systems are described in the MGT
and KMA operating instructions.
The test scope of the EPS 807 / 815 can be extended by
using tester sets (special accessories) from Bosch. Depend-
ing on the tester set, it is then possible to check and set the
latest generation of diesel components (e.g. common rail
injectors and common rail pumps) with the EPS 807 / 815.
!
Further information on the clamping and driving
devices, measuring and test instruments, pressure
lines, test nozzle holders, etc. can be found in the
catalogue "Accessories and optional accessories
for injection pump test benches".
Order no.: 1 689 980 289.
�.2

Requirements

R
The coolant supply must be provided with a pressure
reducing device (set to 250 kPa), a protective filter
and a shutoff valve by the customer.
R
The coolant temperature may max. 17 degrees Cel-
sius; higher coolant temperatures require an appro-
priate cooling device to be provided by the customer.
R
The coolant drainage must be routed into the drainage
line without any shutoff capability over an oil separator.
R
The operator must have a 35 Ampere back-up fuse.
R
The operator must provide noise protection facilities.
R
Training programs on testing diesel components in
the Robert Bosch Test Equipment training center.
Robert Bosch GmbH