Raider RD-AG37 User Manual page 20

20 www.raider.bg
In extremely severe working conditions in cutting of metal on the inner surfaces of the body may
be delayed powder in which current flows. This can disrupt the protective insulation of the grinding
machine. In such cases, it is recommended to use a fixed aspiration system, the frequent blowing of
the vent and the inclusion of electric grinders in safety switch Fi (safety shut-off switch with Residual
protection), and current leakage, which is triggered when Fi should be no more of 30 mA.
Make periodic breaks at work.
Keep and refer to the accessories carefully.
18.2. Replacing the carbon brushes. Worn-out (shorter than 5 mm), or broken carbon brushes of
the engine should be replaced. Always replace both the two brushes. Work on replacement of carbon
brushes entrusted only to qualified specialists with original spare parts in service of RAIDER.
18.3. The repair of your power tool is best carried out only by qualified specialists in service
RAIDER, which used only original spare parts. Thus ensuring their safe operation.
19. Environmental protection.
In view of environmental protection electrical appliances, additional accessories and packing must
be subject to appropriate processing for reuse of the compound materials.
According the European Guideline 2012/19/ЕС for Waste Electrical and Electronic Equipment
and its implementation into national right, power tools that are no longer usable must be collected
separately and disposed of in an environmentally correct manner.
Displayed items:
1. On/Off switch.
2. Protective knob for trigger switch (prevents accidental switching).
3. Button for blocking the shaft.
4. Auxiliary handle
5. Flange alignment.
6. Guard.
7. Additional threaded hole for the auxiliary handle. For greater convenience in operation, auxiliary
handle can be moved left or right of grinders.
8. Retainer nut.