Service Excel 10
I/O Points
The Service Excel 10 menu item allows the operator to display/modify I/O points, display controllers alarms, go into the
controller test mode to exercise hardware inputs/outputs, calibrate temperature sensors and display the controller type and
software version. All points are only read once. Press the Refresh key to read the point data and update the display.
Select the Service Excel 10 menu item from the Main Menu shown below.
M A I N M E N U
Select Excel 10
Service Excel 10
Balance VAV
Configuration
HHt Functions
Five sub-menus are displayed, see the screen below.
S E R V I C E E X C E L 1 0
I/O Points
Alarms
Test Mode
Calibrate Temp Sens
Controller Version
Select the I/O Points menu item. The following screen displays the four sub-menus.
I/O POINTS
Logical Group
Temp Setpoints
Diagnostic Points
Commandable Points
Logical Group
Under the I/O POINTS menu, select the Logical Group menu item. Under the Logical Group heading the operator is able to
display the current value of the points listed in the Logical Group. See Table 4.
Page 11
EXCEL 10 HAND HELD TOOL
74-2566