Product Description; Intended Use - KLING & FREITAG SPECTRA 212 User Manual

Hide thumbs Also See for SPECTRA 212:
Table of Contents

Advertisement

User's Manual
06/16/21
16.06.2021
2.0
SPECTRA 212
2
The SPECTRA 212 is a compact 3-way, convertible line array speaker with equalization in two
ways. Separate K&F power amplifiers are required for driving the SPECTRA 212.
The connection system and the optionally available K&F rigging system allow for creating and
suspending either a horizontal line of up to six SPECTRA 212 or a vertical array of up to four
SPECTRA 212.
The speaker is available in two versions:
These versions can be used both in a line array (in line-source mode) or as a point source (in
point-source mode). To change the operating mode, you need to rotate the internal mid-
range/tweeter unit.
Various point-source modes are available:
2.1
Be sure to use the K&F SPECTRA 212 only with system amplifiers or controllers approved by
KLING & FREITAG.
The product and any optional accessories are suitable for indoor use (exhibition halls, event
halls, etc.). This product is not designed for prolonged use in corrosive environments. Outdoor
operation is permitted, provided that the speaker is protected against direct weather impact.
For outdoor installation, you will need to manufacture appropriate custom fastening equip-
ment with regard to the place and purpose of use. Be sure to take outdoor effects (wind, snow
loads, etc.) into account. The use of standard accessories for temporary or permanent outdoor
installation is not permitted.
When using the optional K&F SPECTRA 212 subwoofer adapter, you can use K&F subwoofers
as a pedestal provided the required stability is ensured. Refer to the manual for K&F SPECTRA
212 accessories for more information. The connection system and the optionally available K&F
rigging system allow for creating and suspending either a horizontal line of up to six SPECTRA
212 or a vertical array of up to four SPECTRA 212. In outdoor use, if the product is suspended
using the optional K&F rigging system, be sure to guy it and to end operation at wind forces
of 8 bft or more. People may safely stand below the structure during operation.
Installation and operation must be performed by qualified event technicians or appropriately
trained persons. Planning must be performed and responsibility be taken by qualified person-
nel only.
Any other use not described in this document is not an intended use.
Page 6 of 39

Product Description

XW (extra wide) with 120° × 30° directivity
N (narrow) with 60° × 30° directivity
Point source with a VariQ midrange/tweeter unit down-tilt by –10°
Asymmetrical vertical directivity (30°× +5 °...–25 °)
In point-source mode with down-tilt, the asymmetrical vertical directivity simplifies orien-
tation towards the audience while reducing unwanted ceiling reflections.
Point source with a VariQ midrange/tweeter unit up-tilt by 10°
Asymmetrical vertical directivity (30°× +25 °...–5 °)
In point-source mode with up-tilt, the asymmetrical vertical directivity simplifies orientation
towards the audience if they are positioned above the speaker.

Intended Use

Version 2.0
K&F SPECTRA 212
© KLING & FREITAG GMBH

Advertisement

Table of Contents
loading

Table of Contents