Product Description; Intended Use - KLING & FREITAG SCENA 12 User Manual

User's Manual
2
K&F SCENA 12 is a compact 2-way coaxial stage monitor. The speaker can be driven either
through separate K&F system amplifiers or linear power amplifiers up to 750 Wrms per channel
(8 ohms). A switch is provided on the connector panel for supporting the use of 4-wire
SpeakOn cables. Thus allowing for toggling between two power-amp channels. Using the
'K&FSCENA 12 speaker-stand adapter, you can also mount the speaker to a speakerstand.
Thanks to its 2-handle design and the low weight of just 18.4 kg (40.56 lbs) the speaker can
be carried by a single person. The speaker dimensions are 497 mm × 299 mm × 469 mm
2.1
Be sure to use the K&F SCENA 12 speaker system only with approved system amplifiers, con-
trollers, or linear amplifiers with a at 750 Wrms output (max.) and an impedance of 8 ohm. For
audio reproduction only.
In general, this product is designed for indoor use. You can also operate it in an outdoor setting
if it is sufficiently protected against rain, water, winds, etc. This product is not designed for
prolonged use in corrosive environments.
Unless otherwise stated, use only KLING & FREITAG original parts specifically designated for
mounting this system.
To be installed and operated by qualified personnel only.
Any other use not described in this document is not an intended use.
© KLING & FREITAG GMBH

Product Description

Intended Use

Version 1.3
K&F SCENA 12
Page 5 of 30