Troubleshooting - Progress PCN43102X User Manual

32 Progress
A
3. Close the oven door to the first
opening position (approximately 70°
angle).
4. Hold the door with one hand on each
side and pull it away from the oven at
an upwards angle.
5. Put the door with the outer side down
on a soft cloth on a stable surface.
6. Hold the door trim (B) on the top edge
of the door at the two sides and push
inwards to release the clip seal.
2
B
7. Pull the door trim to the front to
remove it.
8. Hold the door glass panels on their top
edge one by one and pull them up out
of the guide.
9. Clean the glass panel with water and
soap. Dry the glass panel carefully.

TROUBLESHOOTING

WARNING! Refer to Safety
chapters.
A
1
When the cleaning is completed, do the
above steps in the opposite sequence.
Install the smaller panel first, then the
larger and the door.
One of the hinge-arms
(normally the right one) is free
to move. Make sure, that both
hinge-arms are in the same
position (approximately 70°
angle).
WARNING! Make sure that the
glasses are inserted in the
correct position otherwise the
surface of the door may
overheat.
Replacing the lamp
WARNING! Risk of electric
shock.
The lamp can be hot.
1. Turn off the oven.
Wait until the oven is cooled down.
2. Disconnect the oven from the mains.
3. Put a cloth on the bottom of the cavity.
The top lamp
1. Turn the lamp glass cover to remove it.
2. Clean the glass cover.
3. Replace the lamp with a suitable 300
°C heat-resistant lamp.
4. Install the glass cover.