Energetics POWER RUN 1.8 Owner's Manual page 4

Safety Instructions
To protect the floor or carpet from damage, place a mat under the treadmill.
-
Turn off the power whilst the treadmill is not in use and remove the safety key.
-
In case of emergency please place both feet at the same time on the side reins.
-
To activate an emergency stop, please detach the safety key from the console.
-
Ensure that an area of 2000 x 1000 mm behind the treadmill is free from any obstacles.
-
This product is made for home use only and tested up to a maximum body weight of 100 kilograms.
-
We take no responsibility for personal injury or damage sustained by or through the use of this
-
treadmill.
The noise creation of treadmill is under 70 db.
-
The unit requires a power supply of 220V – 230V / 50 HZ.
-
The function of the immobilization method: the purpose of immobilizing the treadmill is to prevent
-
unauthorized use. This can be accomplished by removing the safety key from the console,
unclipping it from the cord and putting it in a non-accessible place.
The emergency dismount: Follow the steps listed below if you experience pain, feel faint or need to
-
stop your treadmill in an emergency situation:
1.) Grip handrails for support.
2.) Step onto the lateral platform.
3.) Pull the Safety key off the console.
The function of the emergency stop: The safety key functions as the emergency stop. In an
-
emergency situation, remove the safety key from the console and the treadmill will come to a stop.
Noise compliance: This treadmill meets the requirements of the noise pollution standards.
-
Search for noisy parts: If you should notice unusual noises, like grinding, clacking etc. try to locate it
-
and have it repaired by a professional. Make sure the treadmill is not used until after repairs have
been made.
Assembly
1. Open the carton, put the main frame on the ground.
2. Fix the computer basket on the uprights using screws (51) and lock washers (64).
3. Fold and move up the computer together with the uprights. IMPORTANT: When you upfoald the
computer and the uprights, make sure the metal does not damage the inside wires! Fix the upright
onto the base frame with the allen wrench using the screws (70) and washers (64). Repeat the same
on the other side.
4. Attach the safety key to the computer (71).
Handling
Upfolding
Catch the rear end or the running belt (A) and
gently lift the running deckt into an upright position
until you hear that the air pressure bar is locked
into the round tube (B).
Unfolding
Hold the rear end of the running deck (A) and
press on the air pressure bar (B). The running
deck will lower gently to the ground.
4