Pc Software; Pc User Interface; Using The Vampset Program; Remote Control Connections - VAMP 140 Operation And Configuration Instructions

VAMP Ltd
6.
6.1.
6.1.1.
6.2.
VM140.EN011
Overcurrent and earth-fault relay
Operation and Configuration

PC software

PC user interface

The PC interface is intended to be used for onsite
parameterization of the relay and for reading of measured
values to a computer or loading of the relay software from a
computer.
The RS 232 serial port is available for the connection of a local
PC on the front panel of the relay. To connect a PC to the serial
port use a connection cable of type VX 003-3.

Using the VAMPSET program

See separate user's manual for the VAMPSET software,
VMV.EN0xx. If the VAMPSET software is not available please
download it from www.vamp.fi.

Remote control connections

The protection relay communicates with higher-level systems,
e.g. remote control systems, via the serial port (REMOTE) on
the rear panel of the relay.
ModBus, SPA-Bus, IEC 60870-5-103, ProfiBus or ModBus TCP
can be used as REMOTE communication protocols (see details
in Chapter 2.5.2. in technical description).
Additional operation instructions for various bus types are to
be found in their respective manual.
Vamp 24h support phone +358 (0)40 573 6316
VAMP 140
27