Configuring Communication Protocols Com - VAMP 140 Operation And Configuration Instructions

VAMP 140
5.8.
24
Overcurrent and earth-fault relay
Operation and Configuration
Configuring communication protocols
COM
Via the submenus of the COM menu the following functions
can be read and set:
Active
Communication protocol of REMOTE port (Protocol)
•
Message counter (Msg#)
•
Communication error counter (ERRORS)
•
Communication time-out counter (Tout)
•
Profibus
Profibus profile (Mode)
•
Transfer rate of converter
•
Profibus Tx Buf lentgh (InBuf)
•
Profibus Rx Buf lentgh (OutBuf)
•
ProfiBus address (Addr)
•
Type of the ProfiBus converter (Conv)
•
ModBus
Device slave number at ModBus Slave Protocol or
•
target slave number at ModBus Master protocol (Addr)
ModBus transfer rate (bit/s)
•
ModBus parity check (Parity)
•
SpaBus
Slave number (Addr) when relay connected to SPA-Bus
•
SPA-Bus transfer rate (bit/s)
•
Event mode (Emode)
•
IEC-103
Slave address (Addr)
•
Transfer rate (bit/s)
•
TCP/IP (ModBus TCP, only in VAMPSET)
IP address of the relay (IPAddr)
•
Subnet mask (NetMsk)
•
IP address of the Name Server (NameSv)
•
IP address of the SNTP Server (NTPSvr)
•
IP address of the Gateway (Gatew)
•
IP port number for Protocol (Port)
•
Local Port
Transfer rate of local serial bus (bit/s)
•
Vamp 24h support phone +358 (0)40 573 6316
VAMP Ltd
VM140.EN011