Eaton Cutler-Hammer VCP-WR 18 Series Instructions For The Use, Operation And Maintenance page 3

I.B. 8295A61H03
!
IMPROPERLY INSTALLING OR MAINTAINING
THESE PRODUCTS CAN RESULT IN DEATH, SERI-
OUS PERSONAL INJURY, OR PROPERTY DAMAGE.
READ AND UNDERSTAND THESE INSTRUCTIONS
BEFORE ATTEMPTING ANY UNPACKING, ASSEM-
BLY, OPERATION OR MAINTENANCE OF THE CIR-
CUIT BREAKERS.
INSTALLATION OR MAINTENANCE SHOULD BE
ATTEMPTED ONLY BY QUALIFIED PERSONNEL.
THIS INSTRUCTION BOOK SHOULD NOT BE CON-
SIDERED ALL INCLUSIVE REGARDING INSTALLA-
TION OR MAINTENANCE PROCEDURES. IF FUR-
THER INFORMATION IS REQUIRED, YOU SHOULD
CONTACT CUTLER-HAMMER.
All possible contingencies which may arise during installation, operation or maintenance, and all details and
variations of this equipment do not purport to be covered by these instructions. If further information is
desired by purchaser regarding his particular installation, operation or maintenance of particular equipment,
contact a Cutler-Hammer representative.
Effective 7/97
WARNING
Power Distribution Components Division
Five Parkway Center
Pittsburgh, PA 15220
THE CIRCUIT BREAKER ELEMENTS DESCRIBED IN
THIS BOOK ARE DESIGNED AND TESTED TO
OPERATE WITHIN THEIR NAMEPLATE RATINGS.
OPERATION OUTSIDE OF THESE RATINGS MAY
CAUSE THE EQUIPMENT TO FAIL, RESULTING IN
DEATH, BODILY INJURY AND PROPERTY DAM-
AGE.
ALL SAFETY CODES, SAFETY STANDARDS
AND/OR REGULATIONS AS THEY MAY BE
APPLIED TO THIS TYPE OF EQUIPMENT MUST BE
STRICTLY ADHERED TO.
THESE CIRCUIT BREAKER ELEMENTS ARE
DESIGNED TO BE INSTALLED PURSUANT TO
AMERICAN NATIONAL STANDARDS INSTITUTE
(ANSI) STANDARD C37.59. SERIOUS INJURY,
INCLUDING DEATH, CAN RESULT FROM FAILURE
TO FOLLOW THE PROCEDURES OUTLINED IN THIS
MANUAL. THESE CIRCUIT BREAKER ELEMENTS
ARE SOLD PURSUANT TO A NON-STANDARD PUR-
CHASING AGREEMENT WHICH LIMITS THE LIABIL-
ITY OF THE MANUFACTURER.
Cutler-Hammer
!
WARNING
Page iii