T10165
4.2 Operation
4.2.1 Operating the Booklet Maker ON-line
1.
Verify that the set up of the Booklet Maker is completed.
2.
Select "third party output" on the Collator.
.
Press "calibration" on the Collator.
4.
The set will enter the Booklet Maker and remain in the stapling section unstapled.
5.
Verify that the set is completed/correct press the Collator start button.
4.2.2 Operating the Booklet Maker OFF-line
1.
Select manual or automatic start.
Manual start: Make sure that the time delay is set to minimum. Press the manual start
button for each operation.
Automatic start: The set will automatically be stapled as it is inserted in the Booklet
When operating, insert one set at a time. Align the set with your fingertip. When auto-
2.
matic mode is selected, set time delay to allow careful alignment.
NOTE: The manual start button will light up when the next set may be inserted.
Maker.
OPERATOR MANUAL BM 61
21