Table of Contents
Advertisement
Section 2
Setup and Installation
Connecting the
Vitalert 3000 Series
to a Narkomed 2B
Connecting the
Vitalert 3000 Series
to the O.R. Data
Manager
2-4
5. Configure the port on the Narkomed 2C for the same parameters given
in step 4 (see Invoking the Serial Ports Screen in the Narkomed 2C
Operator's Manual).
To connect the Vitalert 3000 Series to a Narkomed 2B anesthesia system:
1. Connect one end of a Vitalink data cable to Port C on the rear of the
Vitalert.
2. Connect the other end of the cable to Port A on the rear of the
Narkomed 2B (see the Narkomed 2B Operator's Manual).
3. Secure all connections using the captive screws provided.
4. Configure the Vitalert's Port C, via the Serial Ports System
Configuration screen, for the following parameters. To ensure proper
communication, the port must be configured exactly as shown below.
BAUD RATE:
DATA BITS:
PARITY:
STOP BITS:
PROTOCOL:
5. Configure Port A of the Narkomed 2B for the same parameters given in
step 4 (see the Configuration section of the Narkomed 2B Operator's
Manual).
To connect the Vitalert 3000 Series to the O.R. Data Manager:
1. Connect one end of a Vitalink data cable to a serial port on the rear of
the Vitalert.
2. Connect the other end of the cable to the Vitalink port on the rear of
the O.R. Data Manager (see the O.R. Data Manager Setup and Installation
Manual).
3. Secure all connections using the captive screws provided.
4. Configure the Vitalert's serial port, via the Serial Ports System
Configuration screen, for the following parameters.
BAUD RATE:
DATA BITS:
PARITY:
STOP BITS:
PROTOCOL:
RETURN TO CD-ROM TABLE OF CONTENTS
1200
8
NONE
1
VITALINK
9600
8
NONE
1
VITALINK
Advertisement
Table of Contents
