Table of Contents
Advertisement
Safety instructions
Security devices
Danger of pressure
Attention
Guards (motor cover, coupling guard, housings, ...) are set
up for safe use of the equipment.
The manufacturer cannot be held responsible for any bodily
injury as well as failures and / or damage to the equipment
resulting from the destruction, the occultation or the total or
partial removal of the protectors.
Never exceed the maximum working pressures of the
equipment components.
Safety requires that a pressure relieve shutoff valve be mounted on
the pump motor supply circuit to allow trapped air to escape when
the supply is shut off.
Without this precaution, the residual air from the engine may cause
the motor pump to operate and cause a serious accident.
Similarly, a material bleed valve must be installed on the material
circuit so that material pressure can be relieved (after shutting off air
motor and decompressing it) before any intervention on the
equipment. These valves should remain closed for air and open for
the material during the procedure.
10
Advertisement
Table of Contents
