Installation - Fantini Cosmi KIT CH130ARR2 Instructions For Use Manual

CH130ARR2

1 - INSTALLATION

ATTENTION!
Installation must be carried out by qualified personnel, in compliance with the requirements concerning
installation of electrical devices. Make sure that the power network is disconnected before making any
connections or working on the device.
The thermostat CH130AR2 is supplied with a base suitable for assembly both wall-mounted and recessed in rectangular
3-place box (503) or round.
Screws
Fixing
hole
Base
■ Remove the top cover of the thermostat.
■ Divide the base and front of the thermostat by removing the screws with a specific tool and extracting the front part.
■ Fix the base to the required surface by means of the specific fixing holes; and make sure that the base is well secured,
without deformations and that the multi-polar connector is at the bottom right corner.
■ For proper operation, the base must be approximately 1.5 metres above the floor, away from heat sources (direct
sunlight, etc.) and from doors and windows.
■ Insert the thermostat on the base and screw it, making sure that the multi-polar connector is inserted properly.
■ Refit the top cover.
FAN COIL ROOM THERMOSTAT
Fixing
hole
Multi-polar
connector
Screws
Fixing
hole
6