Kohler KD83V16 Service And Repair Manual page 291

Service and Repair Manual
Size
M60x2
Tab. 77: VSTI screw plug tightening torques for aluminium parts
1) Do not use hydropneumatic screwdriver.
5.3.11 Assembling pipes with DKO connectors (EL, ET, EW, GZ, GZR,
RED)
Fig. 352: DKO connector
Fig. 353: DKO connector lubrication
Information
Tolerances of the indicated tightening torques: 10 %.
Always lubricate the thread before tightening these parts (engine oil).
Information
To assemble pipes with DKO connectors, observe the following steps:
u When tightening the nut, make sure the connector does not rotate.
u Tighten the nut by hand.
u Hold a wrench as close as possible to the nut.
u Tighten the nut with the wrench until the resisting point.
u Tighten the nut a further 90°.
Alternatively, refer to the following table for tightening sequence of the nut:
Size
06L
KD83V16 33525088901_2_1 EN_US
2021-07
Tightening torque
1) VSTI ED VSTI o-ring
- 400 Nm
295 ft-lb
Equivalent specification
20 Nm
15 ft-lb
© 2021 by Kohler Co. All rights reserved.
Size Tightening torque
1) VSTI ED
-
Size Equivalent specification
06S 25 Nm
18 ft-lb
Appendix
Standard tightening torques
VSTI o-ring
- -
291