Kohler KD83V16 Service And Repair Manual page 187

Service and Repair Manual
Installation
u Install compensators 1 with seals 2 and V-clamps 3.
u Tighten V-clamps 3 to torque.
Specific values
Not applicable.
Tightening specifications
Fig. 211: V-clamps
1 410AF
Tab. 41: Tightening specifications table
*Lubricants:
MG = Molykote G-n-plus
MW = Castrol Optimol paste white T
MH = Molykote HSC
O = Engine oil
XX = Loctite 243
YY = Loctite 577
**Refer to screws reuse rules.
marking, page 274.)
Exhaust pipes removal and installation
Previous tasks
q Remove turbocharger.
installation (SL 213), page 170.)
KD83V16 33525088901_2_1 EN_US
2021-07
Key Screw specifications
M8x1.25
(For more information see: 5.3.2 Screws pre-tightening, reuse and
(For more information see: 3.8.3 Exhaust gas turbocharger removal and
© 2021 by Kohler Co. All rights reserved.
Torque
± 5%
MH Yes 1 20 Nm
15 ft-lb
Repair
Exhaust gas system
Angle (°)
± 5°
- -
187