İsteğe Bağlı Boss S1 Kartı; Removing The Boss S1 Card - Dell EMC PowerEdge XR11 Installation And Service Manual

Hide thumbs Also See for EMC PowerEdge XR11:

Table of Contents

Available languages

Figure 75. Installing expansion card in Riser 2 and 3

Next steps

1. Follow the procedure listed in

2. Install any device drivers required for the card as described in the documentation for the card.

NOTE:

While replacing faulty storage controller or NIC or the GPU card with the same type of card, after you power on the

system, the new card automatically updates to the same firmware and configuration of the faulty one. For more information

about the Part replacement configuration, see the Lifecycle Controler User's Guide at

İsteğe bağlı BOSS S1 kartı

Prerequisites

1. Follow the safety guidelines listed in the

2. Follow the procedure listed in the

NOTE:

The procedure to remove the BOSS S1 card is the same for Rear Accessed and Front Accessed configurations.

Steps

Holding the blue tag, pull the BOSS S1 card away from the system board connector.

sistem içinde çalıştıktan

sonra.

Safety

instructions.

Before working inside your

system.

Sistem bileşenlerini takma ve çıkarma

https://www.dell.com/idracmanuals

Table of Contents