Installing The Power Interposer Board (Pib) - Dell EMC PowerEdge XR11 Installation And Service Manual

Installing the power interposer board (PIB)

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
NOTE: The procedure to install the power interposer board (PIB) is the same for Rear Accessed and Front Accessed
configurations.
Steps
1. Align the slots on the PIB with the hook on the system and slide it into place.
2. Using Phillips 2 screwdriver, tighten the screws to secure the PIB to the system.
Figure 91. Installing the power interposer board
3. Reconnect all the required cables.
Next steps
1. Install the PSU.
2. Install the PCI air shroud.
3. Follow the procedure listed in
Safety instructions.
Sisteminizin içinde çalışmaya başlamadan
sistem içinde çalıştıktan sonra.
önce.
Sistem bileşenlerini takma ve çıkarma 91