Installing The Processor And Heat Sink Module - Dell EMC PowerEdge XR11 Installation And Service Manual

Rakam 56. Isı emicisini işlemciye takma
Sonraki Adimlar
1. Isı emiciyi yerine takın.
2. İşlemci hava örtüsünü yerine
3. sistem içinde çalıştıktan sonra

Installing the processor and heat sink module

Prerequisites
Never remove the heat sink from a processor unless you intend to replace the processor or system board. The heat sink is
necessary to maintain proper thermal conditions.
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. Remove the processor air
NOTE: The procedure to install the heat sink is the same for Rear Accessed and Front Accessed configurations.
Steps
1. Set the anti-tilt wires to the unlocked position on the heat sink (inward position).
2. Align the pin 1 indicator of the heat sink to the system board, and then place the processor and heat sink on the processor
socket.
CAUTION: To avoid damaging the fins on the heat sink, do not press down on the heat sink fins.
NOTE: Ensure that the processor and heat sink is held parallel to the system board to prevent damaging the
components.
takın.
bölümünde listelenen prosedürü izleyin.
Safety instructions.
Sisteminizin içinde çalışmaya başlamadan
shroud.
önce.
Sistem bileşenlerini takma ve çıkarma 65