Removing The Power Button Control Panel For Front Accessed Configuration - Dell EMC PowerEdge XR11 Installation And Service Manual

Figure 105. Installing the status LED control panel assembly for Front Accessed configuration
Next steps
1. Install the expansion card riser
2. Install the processor heat sink
3. Install the air shrouds.
4. Follow the procedure listed in the
Removing the power button control panel for Front Accessed
configuration
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. Remove the Riser 1.
Steps
1. Loosen the three screws to remove the left ear for the Front Accessed configuration.
2. Disconnect the power button control panel cable from the system board connector and remove the cable from cable clip.
NOTE: Observe the routing of the cable as you remove it from the system.
3. Using the Phillips 2 screwdriver, remove the screws that secure the left rack ear.
4. Using the Torx 8 screwdriver, remove the screws that secure the power button control panel assembly.
5. Hold the power button control panel assembly and remove the control panel along with the cable from the system.
NOTE: Resimdeki numaralar tam olarak adımlara karşılık gelmez. Numaralar sırayı göstermek içindir.
104 Sistem bileşenlerini takma ve çıkarma
1.
module.
After working inside your
Safety instructions.
Sisteminizin içinde çalışmaya başlamadan
system.
önce.