Optional Boss S2 Module; Removing The Boss S2 Module - Dell E76S Installation And Service Manual

Figure 107. Installing a memory module
Next steps
1. Install the air shroud.
2. Follow the procedure listed in
3. To verify if the memory module has been installed properly, press F2 and navigate to System Setup Main Menu > System
BIOS > Memory Settings. In the Memory Settings screen, the System Memory Size must reflect the updated capacity of
the installed memory.
4. If the System Memory Size is incorrect, one or more of the memory modules may not be installed properly. Ensure that the
memory modules are firmly seated in their sockets.
5. Run the system memory test in system diagnostics.

Optional BOSS S2 module

Removing the BOSS S2 module

Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure that is listed in
3. Remove the air shroud.
4. If installed, remove the front
5. Disconnect the cables connected to the system board.
.
Steps
1. Using a Phillips 2 screwdriver, remove the screw securing the BOSS S2 module to the system.
2. Slide the BOSS S2 module out of the system.
NOTE: The procedure to remove the BOSS S2 module is similar for all configurations.
After working inside your
Safety instructions.
Before working inside your
bezel.
system.
system.
Installing and removing system components 111