Installing The Power Button Control Panel For Rear Accessed Configuration - Dell EMC PowerEdge XR11 Installation And Service Manual

Installing the power button control panel for Rear Accessed
configuration
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. Remove the air shrouds.
4. Remove the expansion card riser
Steps
1. Route the power button control panel cable through the side wall of the system.
NOTE: Route the cable properly to prevent the cable from being pinched or crimped.
2. Align and insert the right control panel in the slot on the system.
3. Connect the power button control panel cable to the connector on the system board.
4. Using the Torx 8 screwdriver, tighten the screws that secure the right control panel to the system.
NOTE: Resimdeki numaralar tam olarak adımlara karşılık gelmez. Numaralar sırayı göstermek içindir.
Figure 102. Installing the power button control panel for Rear Accessed configuration
5. Using the Phillips 2 screwdriver, tighten the screws that secure the right ear handle to the system.
NOTE: Resimdeki numaralar tam olarak adımlara karşılık gelmez. Numaralar sırayı göstermek içindir.
Safety instructions.
Before working inside your
1.
system.
Sistem bileşenlerini takma ve çıkarma 101