Removing The Processor From The Processor Heat Sink Module - Dell EMC PowerEdge XR11 Installation And Service Manual

Figure 49. Removing a heat sink
Next steps
If you are removing a faulty heat sink,

Removing the processor from the processor heat sink module

Prerequisites
WARNING: Remove the processor from the processor and heat sink module (PHM) only if you are replacing the
processor or heat sink.
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. Remove the processor air
4. Remove the heat sink.
NOTE: The procedure to remove the processor is the same for Rear Accessed and Front Accessed configurations.
CAUTION: You may find the CMOS battery loss or CMOS checksum error that is displayed during the first
instance of powering on the system after the processor or system board replacement which is expected. To fix
this, simply go to setup option to configure the system settings.
Steps
1. Place the heat sink with the processor side facing up.
2. Using your thumb lift up the Thermal Interface Material (TIM) break lever to release the processor from the TIM and carrier.
3. Holding the processor by the edges, lift the processor away from the carrier.
NOTE: Ensure to hold the carrier to the heat sink as the TIM break is rotated.
60 Sistem bileşenlerini takma ve çıkarma
replace the heat
Safety instructions.
Sisteminizin içinde çalışmaya başlamadan
shroud.
sink, if not, remove the processor.
önce.