Power-Button Board; Removing The Power-Button Board - Dell W29C Service Manual

Steps
1. Slide the media-card reader under the system board and align the screw hole on the media-card reader with the screw hole
on the display-assembly base.
NOTE: Ensure that the media-card reader cable stays above the system board.
2. Connect the media-card reader cable to the system board and close the latch to secure the cable.
3. Replace the screw (M3x3.5) that secures the media-card reader to the display-assembly base.
Next steps
1. Install the system-board
2. Install the I/O cover.
3. Install the back cover.
4. Install the stand.
5. Follow the procedure in

Power-button board

Removing the power-button board

Prerequisites
1. Follow the procedure in
2. Remove the stand.
3. Remove the back cover.
4. Remove the I/O cover.
5. Remove the system-board
About this task
The following image indicates the location of the power-button board and provides a visual representation of the removal
procedure.
46 Removing and installing components
shield.
After working inside your
Before working inside your
shield.
computer.
computer.