2
Remove the battery pack.
i)
Remove the battery cover.
• See i) in step 2 of "4.1 Preparing to use the detector" for operating procedures.
ii)
Remove the battery pack.
• Insert your fingers into the slot of the
battery pack bay to grip the battery
pack edge, and then pull the edge to
remove the battery pack (
iii)
Attach the battery cover.
• See iii) in step 2 of "4.1 Preparing to
use the detector" for operating
procedures.
3
Place the detector in its storage location.
4.4
List of detector status indication
Detector status
Power OFF
Power ON
Linkage started
Switching to exposure ready status
Exposure ready status
Detector selection status (Sleep)
Error
*
The indication of the Power LED lamps changes according to the remaining battery charge
(➞ page 36).
** Only after linkage from the detector
).
Status indicators
Power LED*
Not illuminated
Illuminated
Illuminated
Illuminated
Illuminated
Illuminated
Flashing
4
Operating procedures
READY LED
Not illuminated
Not illuminated
Flashing (3 sec. only)**
Flashing
Illuminated
Not illuminated
Flashing
41