Advertisement
l i n d a b | we s i m p l i f y c o n s t r u c t i o n
Sliding dampers
SKMTR, SKPTR
Assembly
Install the damper as per instructions for straps or flanges.
Check that the space before/beyond the damper allows the damper blade to be fully opened.
When installing SKPTR with automatic opening and closing function, the risk of personal injury must be
considered. The damper must therefore be installed outside any possible contact zone, for example min.
2.1 m above the floor.
Connecting conduits must be suspended so that the damper is not exposed to destructive forces. These
can cause the damper to jam or stick.
Example of horizontal installation.
Electrical connection
Electrical connection must not be performed before the damper is connected to the pipe system or the
pipe connections are covered in some other way.
Electricity must be connected by a qualified electrician. Connection must be carried out in accordance
with the adjoining diagram.
The motor must, however, be preceded by a multi-pin switch with a break distance of at least 3 mm.
Wiring diagram
2
Advertisement
