Prepare For Installation / Reset; Installation - Philio PHI PST02-1B Quick Start Manual

When included securely the device is able to accept secure commands and to send secure commands to other devices. The commands and the rece
commands sent out on single click and on double click of the rocker can be defined in configuration parameters and association groups.

Prepare for Installation / Reset

Please read the user manual before installing the product.
In order to include (add) a Z-Wave device to a network it must be in factory default state. Please make sure to reset the device into factory default. You ca
by performing an Exclusion operation as described below in the manual. Every Z-Wave controller is able to perform this operation however it is recommend
the primary controller of the previous network to make sure the very device is excluded properly from this network.
Reset to factory default
This device also allows to be reset without any involvement of a Z-Wave controller. This procedure should only be used when the primary controller is inope
1. Pressing tamper key four times within 1.5 seconds and do not release the tamper key in the 4th pressed, and the LED will light ON.
2. After 3 seconds the LED will turn OFF, after that within 2 seconds, release the tamper key. If successful, the LED will light ON one second. Otherwise
will flash once.
3. IDs are excluded and all settings will reset to factory default.
Safety Warning for Batteries
The product contains batteries. Please remove the batteries when the device is not used. Do not mix batteries of different charging level or different brands.

Installation

Battery Installation
When the device report the low battery message. The user should replace the battery to new one. The battery type is CR123A, 3.0V. The way to open the f
please follow below steps.
Using a tool to press the 1-1 position, to release the cover.
Hold the front cover and pull back
Hold the front cover and pull up
Replace the new battery and install the cover back.
Put the front cover bottom to 1-1, and press down.
Push the front cover top to 2-1.
http://manual.zwave.eu/backend/make.php?lang=en&sku=PHI_PST02-1B
06-10-2020 14:42
Pagina 2 van 9