Philio PHI PST02-1B Quick Start Manual page 6

Z-wave 3 in 1 sensor (motion, illumination, temperature)

Hide thumbs Also See for PHI PST02-1B:

Quick start manual (8 pages)

Table of Contents

Setting

128

Parameter 6: Mult-Sensor Function Switch

Multisensor function switch. Using bit to control.

Size: 1 Byte, Default Value: 4

Setting

128

Parameter 7: Customer Function

Customer function switch, using bit control.

Size: 1 Byte, Default Value: 4

Setting

128

Parameter 8: PIR Re-Detect Interval Time

In the normal mode, after the PIR motion detected, setting the re-detect time. 8 seconds per tick, default tick is 3 (24 seconds).Setting the suitable value to

received the trigger signal too frequently. Also can save the battery energy.Notice: If this value bigger than the conﬁguration setting NO. 9. There is a period

light turned off and the PIR not start detecting.

Size: 1 Byte, Default Value: 3

Setting

1 - 127

Parameter 9: Turn Off Light Time

After turn on the lighting, setting the delay time to turn off the lighting when the PIR motion is not detected. 8 seconds per tick, default tick is 4 (32 seconds).

never send turn off light command.

http://manual.zwave.eu/backend/make.php?lang=en&sku=PHI_PST02-1B

Description

Reserve.

1 means test mode, 0 means normal mode. Notice: This bit only effect by the DIP Switch setting to "cust

mode", otherwise it decides by DIP Switch setting to Test or Normal Mode

Reserve.

Setting the temperature scale. 0: Fahrenheit, 1:Celsius

Disable the illumination report after event triggered. (1:Disable, 0:Enable)

Disable the temperature report after event triggered. (1:Disable, 0:Enable)

Reserve.

Disable the back key release into test mode. (1:Disable, 0:Enable)