Troubleshooting; Service Requirements - Pacvac Hydropro Series Product & Training Manual

Troubleshooting

Caution: Always unplug the machine before attempting to solve a problem or when servicing.
Problem Cause
Power cord not firmly plugged into
power point.
Vacuum Vacuum cleaner not turned on.
cleaner not
working.
Circuit breaker or RCD has tripped.
Dust bag full.
Dust bag not installed correctly.
Vacuum
cleaner has
Hose not installed correctly.
no/poor
suction.
Blockages.
Filters blocked.
Filter not installed correctly.
Latches do Vacuum head is not placed properly
not clamp on tank.
properly.
Latches have been damaged and
deformed.

Service Requirements

Our products are designed and built to be functional and durable. For information on use and maintenance
please read this Product & Training Manual thoroughly.
Should you require servicing contact your nearest Authorised Pacvac Service and Warranty Agent.
Hydropro series
Solution
Plug power cord into power point firmly.
Press on/off button.
Check the machine is in good working order. If OK,
reset circuit breaker or RCD. If circuit breaker or
RCD trips again contact your nearest Authorised
Pacvac Service and Warranty Agent.
Remove, empty and clean dust bag.
Remove and empty dust bag making sure the
rubber seal is fitted correctly.
Reconnect hose and ensure correctly sealed.
Remove hose, wand and floor tools; remove any
blockages.
Clean filters.
Refit filter making sure the rubber edging is correctly
fitted around the canister.
Reposition vacuum head on tank and clamp down.
Lightly warm latches with a heat gun. Latches will
then return to their original shape. Wait until latches
have cooled down before resuming use.
9