Operate Right; How To Swap A Floor Tool Insert - Pacvac Hydropro Series Product & Training Manual

Operate Right

How to vacuum easier and faster with no back strain.
1. Fit the appropriate floor tool or swap insert by sliding out the end panels on the floor tool, fitting insert
and then sliding end panels back into position (Refer to diagram below).
2. Stand upright, with the bent handpiece section parallel to the floor.
3. Hold the bent handpiece with one hand at a comfortable arm's length. Use your free hand to hold the
hose to help guide the vacuum as you work.
4. Move forward and away from the power point.
5. Use easy underarm swinging motion when detail cleaning and short dabs when spot cleaning, always
standing upright.
6. Once the end of the power cord has been reached and work completed, return to the power point along
the cord line and disconnect the power cord from the power point.
7. If work is not completed move to the next area, connect power cord to the nearest power point and
repeat steps 1 through 6.
8. If work is completed disconnect power cord from power point then wind from the canister towards
the end of the power cord to reduce likelihood of cable twists. In the process check for nicks, cuts,
fractures, and knots.

How To Swap A Floor Tool Insert

1
Push end panels of floor tool outwards to unlock.
2
Fit appropriate insert into floor tool.
3
Push end panels of floor tool inwards to lock.
NOTE: Above applies to Hydropro 36 and Hydropro 76 floor tools only.
Hydropro series
7