Troubleshooting - Pacvac Hydropro Series Product & Training Manual

Troubleshooting

Caution: Always unplug the vacuum cleaner before attempting to solve a problem or when servicing.
PROBLEM:
Vacuum cleaner not working
Vacuum cleaner has no/poor
suction
Latches do not clamp properly. Vacuum head is not placed
CAUSE:
Power cord not firmly plugged
into power point.
Vacuum cleaner not turned on. Press on/off button.
Circuit breaker or RCD has
tripped.
Dust bag full.
Dust bag not installed
correctly.
Hose not installed correctly.
Blockages.
Filters blocked.
Filter not installed correctly.
properly on tank.
Latches have been
damaged and deformed.
Support: +61 8 9479 1444
SOLUTION:
Plug power cord into power point
firmly.
Check the machine is in good working
order. If OK, reset circuit breaker or
RCD. If circuit breaker or RCD trips
again contact your nearest Authorised
Pacvac Service and Warranty Agent.
Remove, empty and clean dust bag.
Remove and empty dust bag making
sure the rubber seal is fitted correctly.
Reconnect hose and ensure correctly
sealed.
Remove hose, wand and floor tools;
remove any blockages.
Clean filters.
Refit filter making sure the rubber edging
is correctly fitted around the canister.
Reposition vacuum head on tank and
clamp down.
Lightly warm latches with a heat gun.
Latches will then return to their original
shape. Wait until latches have cooled down
before resuming use.
www.pacvac.com 7