Setting Up Date And Time - Berger & Schroter LN-G3-B50 User Manual

SETTING UP DATE AND TIME:

As your viewer has capability to take images and record
video, time and date is automatically stamped onto each
image and video recording. To set the correct date and time,
please follow this procedure:
Turn the unit ON. After image appears, press onto the
Menu/Controller (8) and hold it for approximately 2 seconds
to activate the menu. Select "Settings", then "Date/Time"
To adjust the numbers, rotate the Controller in either di-
rection. To switch between numbers, short-press onto Controller. After Date is set,
adjust the time. Time is in 24hr format, so 13:00 is 1pm; 17:30 is 5:30pm and so
on. As with the date, changing hours and minutes is done by rotating the Controller
and moving between hours and minutes is done by pressing onto it. Once the time
is adjusted you may choose to change the date format to MM/DD/YYYY or
YYYY/MM/DD according to your preference. Once you are finished setting date
and time, you can exit the menu by pressing Controller for approximately 2 se-
conds. Once set, the time will be displayed on the bottom of the image display.
IMPORTANT: in order to preserve the set date/time do not remove the dead bat-
teries from the unit until you are ready to replace them with the new set, then re-
place the old batteries with new set as quickly as possible and the date/time will
be preserved.
USING INFRARED ILLUMINATOR:
Your digital viewer is equipped with a built-in powerful Infrared illuminator light (2).
This light operates in a spectrum, which is normally invisible to a human eye, ho-
wever with the help of the Image Sensor, located inside the binocular, you will see
a beam of light when looking though the ocular lens. Since the Image Sensor does
not actively amplify the available light, you will need to utilize the IR illuminator often
in the nighttime conditions.
WARNING:Your IR illuminator is a Class-3R
LASER
laser product. DO NOT LOOK DIRECTLY
3R
INTO THE IR ILLUMINATOR LENS WHILE
LASER RADIATION
THE ILLUMINATOR IS ON!
AVOID DIRECT EYE EXPOSURE
CLASS 3R LASER PRODUCT
To turn the Infrared illuminator ON, short press the Power & IR button (5) – the IR
icon on the bottom of the display will light in pink color. The illuminator intensity
can be further increased by short-pressing the IR button (5) second and third time.
31